Paint Protection Process

To apply the Glare paint protection takes about 4-5 hours.

1. Wash

2. De-wax with water base de-waxer.
This gives the applicator a close up feel of the car & removes all waxes & polishes. After all we want the paint back to its natural state & true colour before we seal it.

3. If there is any industrial fall out, this is removed by use of liquid clay/ block.
95% of cars done require this, especially if cars were imported or have been standing in holding yards.

4. A pre-cleaner is applied to prepare paint. This step also fills in (it is NOT advisable to buff/cut back fresh uncured paint).

5. If there are spider-web marks (from incorrect washing) or swirl marks (from previous inferior product applied), this is fixed by use of our Spider-web/ swirl remover.

1- 1.5 hrs additional required.

6. The first coat of paint protection is applied.

7. The final seal coat is applied to the entire vehicle including the exterior windows & wheel rims.

This is left to cure before buffed off.

8. All exterior rubbers, plastics door jams, under bonnet plastics and rubber are treated as part of our basic service.

9. The car is returned in a better than new condition. If required, a copy of before/after pictures can be supplied on disc.

10. Balance of paint protection is returned to a customer with a After Care Kit.